About PAMC
Pars Advanced Materials Complex (PAMC) is the 1st and the only industrial complex working in the field of powder metallurgy in Isfahan.
The Advantages of Powder Metallurgy Technique
- High Production Rate along with Low Unit Cost.
- Production of Complicated Forms along with a Uniform Microstructure.
- Full Capacity for Producing a Variety of Alloying Systems, Compounds and Particulate Composites.
- Flexibilitis for Producing PM Parts with Specific Physical and Mechanical Properties such as Hardness, Strength, Density and Porosity.
- The Possibility for Producing Slef Lubricant PM Parts.
The Advantages and Disadvantages of PM Compared with Other Production Routes
| Production Route | Advantages Compared With PM | Disadvantage Compared With PM |
| Cold Forging | Better Strength | Tool Wear, Materials Limitation |
| Extrusion | Production Speed, Long Part And Tube Production, Good Surface Finished. | Low Dimensional Tolerances, Constant Cross Sectional Area, Tool Wear, High Energy Consumption |
| Sheet Rolling | Flat Sheet Production | Only Simple Sections With Equal Cross Section Can Be Produced, Materials Limitation |
| Casting | Production Of Variety Of Different Shapes, Diversity In Materials, Low Unit Cost | Refractories And Ceramics, Non Uniform Microstructure, Directional And Large Grain Sized, Cavities And Voids |
| Hot Forging | Better Mechanical Properties | Low Dimensional Tolerances, Materials Limitation |
| Machining | No Need For Tooling | High Unit Cost, High Materials Waste, Materials Limitation |